S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Remove and hang the engine block heater (if applicable) on the left front mounting for the sub-frame.
Remove the fuel line for the engine block heater (if applicable) on the sub-frame from the snap fasteners.
Position a lifting table under the sub-frame.
Apply the lifting table so that the load is taken off the sub-frame screws.
Remove the sub-frame screws together with the accompanying brackets and washers.
Carefully lower the sub-frame approximately 50 mm.
Note! Ensure that the steering gear screws are released from the sub-frame.
Remove the bracket for the heated oxygen sensor (HO2S) from the sub-frame (does not apply to diesels).
Lower the sub-frame a further 40 mm.
Pressing out the bushings