S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Seals and Gaskets: Service and Repair
Sealing Ring, Crown Wheel Shaft, Left-Hand Side, Replace
Sealing ring, crown wheel shaft, left-hand side, replace
Special tools:
999 7086 Puller See: Tools and Equipment/999 7086 Puller
999 7087 Drift See: Tools and Equipment/999 7087 Drift
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information is always correct.
Preparatory work
Removing bevel gear
Remove the bevel gear.
Removal
Removing the sealing ring
Position the bevel gear on a workbench. Support the gear using a wooden block.
Use extractor 999 7086 Puller See: Tools and Equipment/999 7086 Puller together with spacer ring 7086-1. Knock the seal towards the housing using
the extractor sleeve.
Remove the seal using the impact driver handle of the extractor.
Check thoroughly that no seal residue remains.
Draining the bevel gear oil
Position the bevel gear over a container. Remove the level plug. Allow the oil to run out through the bearing. Wipe away spilt oil from the sealing ring
seat on the bevel gear. Use a lint-free rag.
Installation