S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Clean the constant velocity joint components thoroughly
Note! Replace the drive shaft assembly if any component has cracking or wear damage. Scratches and minor pitting of the ball tracks are
permitted.
Installing the inner ring in the ball holder
Install the inner ring in the ball holder.
Locate the markings to each other. Install a ball bearing.
Note! Ball location.
Turn the inner ring and the ball bearing holder.
Install the balls one by one in the same positions as before. See Removing the balls.
Lubricating the constant velocity joint
Lubricate the constant velocity joint thoroughly.
Apply grease behind the joint via the shaft hole in the inner ring.
Use half of the grease packet. The remainder will be used later in the boot. See Greasing the boot.
Replacing the circlip