S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Use a jimmy bar with a flat surface. Turn the flat surface towards the transmission housing.
Install the drive shaft seal
Note! Clean thoroughly before installing the new seal
Apply a small amount of grease to the sealing lip.
Use drift 999 5541 PUNCH See: Tools and Equipment/999 5541 Punch and shaft 999 1801 STANDARD SHAFT See: Tools and Equipment/999 1801
Standard Shaft.
Place the side of the drift marked M56 against the drive shaft seal.
Install the right drive shaft in the transmission
See Drive shaft right, replacing See: Axle Shaft Assembly/Service and Repair/Drive Shaft Right, Replacing
See, , and
Sealing Ring Connecting Socket Drive Shaft/Differential, Replacing
Sealing ring connecting socket drive shaft/differential, replacing
Special tools:
999 2615 Hydraulic pump See: Tools and Equipment/999 2615 Hydraulic Pump
999 5069 EXTRACTOR See: Tools and Equipment/999 5069 Extractor
999 5575 PULLER CYLINDER USED WITH HYDRAULIC PUMP -5576 See: Tools and Equipment/999 5575 Puller Cylinder Used With Hydraulic
Pump -5576
999 5576 HYDRAULIC PUMP See: Tools and Equipment/999 5576 Hydraulic Pump
999 5654 Punch See: Tools and Equipment/999 5654 Punch
999 5656 Counterhold See: Tools and Equipment/999 5656 Counterhold
999 5657 Punch See: Tools and Equipment/999 5657 Punch
999 5777 Extractor See: Tools and Equipment/999 5777 Extractor
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information in the illustrations is always correct.
Preparatory work