S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Removing the wheel sensor
Clean the area around the wheel sensor and remove the screw. Carefully remove the sensor from the wheel spindle.
Bind the sensor so it is well protected.
Removing the spring strut
Remove the spring strut from the control arm.
Note! There is some tension in the spring strut.
Removing the rear wheel hub
Use a mobile jack to raise the wheel suspension until there is approx. 400 mm between the fender edge and the center of the wheel hub to provide the
best accessibility to the wheel hub screws. See also fender edge measurement.
Remove:
-
the 4 screws