S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
![background image](/volvo/s60_t5/l5-2.3l_turbo_vin_53_b5234t3/Page-2186011.png)
Note! The tape adheres immediately.
Caution! Incorrect positioning of the sensors may result in partial or complete malfunction.
Installing the sensors and cable harness
Note! Applies to left-hand drive cars. When installing on the right-hand drive cars, the connector on the cable harness must protrude from the
left-hand side of the bumper.
-
Take the sensors and cable harness from the kit
-
Install the two inner sensors in the sensor holders so that they engage securely. The outer sensors are installed from underneath after the bumper is
reinstalled on the car
-
Connect the cable harness connectors to the sensors. The loose connector for the cable harness must now protrude from the side of the bumper.
See the illustration.
Note! A click should be heard when connecting. The noise confirms that the catch has locked.
-
The cable harness must be secured along the inside edge of the bumper above the foam. Secure the cable. Use butyl tape. Use activator (P/N
8637076) as an undercoat to increase adhesion.
-
Reinstall the foam and rear section in the bumper cover
-
Reinstall the two clips on the underneath of the bumper cover
-
Ensure that all catches secure properly.