S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
-
Install the heat deflector plate (1). Secure the heat deflector plate using the screw (7) and the washer (6)
-
Reinstall the rubber mounting (8) for the silencer.
Hint: Use normal soap to facilitate installation of the rubber mounting.
-
Tighten the screws (2). Tighten to 120 Nm (90 lbf.ft). Tighten the screws (3, 4). Tighten to 90 Nm (68 lbf.ft) on both sides
-
Underseal the car.
Applies to Sweden only:
-
Carry out this operation only after the state road worthiness inspection.
-
Install the cable harness for the tow hitch according to point 2 onwards in the Installation Instructions for the appropriate cable harness.
When installing a 7-pin or 13-pin cable harness for the tow hitch, a cut out (2) must be made in the lower edge of the bumper
-
Loosely install the bumper. Make markings for the cut-out for the cable harness
-
Cut out as illustrated so that there is room for the cable harness.
Finishing work and function test