S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
-
Install a washer plate (6) on the left-hand side on the front screw (4). This is to secure the rear mounting for the heat deflector plate using the screw
(7). (See illustration B)
Illustration B
-
Install the heat deflector plate (1) and secure it using the screw (7) for the washer plate (6).
-
Reinstall the rubber mounting (8) for the silencer.
HINT: Use normal hand soap to facilitate installation of the rubber mounting.
Illustration A
-
Tighten the screws (2). Tighten to 114 Nm (84 lbf.ft).
Tighten the screws (4). Tighten to 81 Nm (60 lbf.ft), on both sides.
-
Underseal the car.
Installing the cable harness
-
Install the cable harness for the towbar according to the Installation Instructions for the appropriate towbar wiring.
-
When installing a 7-pin or 13-pin cable harness for the towbar, a cut-out (2) must be made for these in the lower edge of the bumper: