S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
Release the upper catches using a weatherstrip tool. Lift out the control module.
Note! Check that the control module's connectors are intact.
Installing the passenger door module (PDM)
Press the control module into place.
Install:
-
the connectors
-
the nut and screw
-
the door panel, see Replacing the front door side panel See: Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and
Repair/Removal and Replacement/Front Door Side Panel.
Ordering software
Order software for the passenger door module (PDM) according to the table below.
Finishing
Initialise the window position in the communication input.
Relay/Fuse Box Cargo Compartment/Rear Electronic Module (REM), Replacing
Relay/fuse box cargo compartment/Rear electronic module (REM), replacing
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information in the illustrations is always correct.
Exposing the integrated relay/fusebox in the cargo compartment