S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
NOTE: It is arbitrary which of tools 999 5575, 999 5576 and 951 2564 is used.
Lifting the sub-frame
-
Lift the sub-frame up completely.
-
At the same time locate the mounting screws for the steering gear on the sub-frame.
-
Install the sub-frame brackets loosely together with the washers.
-
Install the four screws for the sub-frame. Use new screws. Do not tighten yet.
-
First tighten the screws on the left side of the sub-frame. Tighten to 105 Nm. Angle-tighten 120 degrees. Then tighten the right-hand side to the
same values as the left side.
-
Finally tighten the screws for the brackets on both sides. Tighten to 50 Nm.
-
Install the engine block heater (if applicable) on the left front mounting for the sub-frame.
CAUTION: Tighten the left-hand side first. The sub-frame guides are on the left-hand side.
Installing the nuts and screw for the steering gear
Install: