S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
-
Remove the rivet (1) on the bracket (2) for the silencer. Use cutting nippers
-
Remove the screws (3) on the bracket
-
Remove the rubber mountings (4). Remove the bracket. The bracket will not be used again.
Illustration 7B
-
Remove the screws (1). Remove the bracket (2). The bracket will not be used again.
Illustration A
-
Install masking tape on the outside of the bumper to avoid damage from the saw
-
Leave the masking tape in place throughout the installation procedure
-
Cut out along inside of flange (1) on the underside of the bumper so that the flange stays in place in the bumper
-
Also cut out the shaded areas on both sides of the flange following the markings on the bumper
-
After cutting, smooth off the edges using a file.
Only applies if the car is equipped with mouldings:
-
Also cut out the moulding following the instructions (2).
Illustration B applies to the V70-R