S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
result in loads to the pad and/or wire that damage the pad. (The type of seam on the upholstery may cause wear in the long term).
The surface of the heater pad during installation
Caution! There must not be any bubbles or kinks when the heater pad is bonded to the foam filling.
Bubbles and kinks increase the risk of damage to the pad during use
Note! This applies to the entire surface, but to the heating wires in particular.
Finishing work after the heater pad has been bonded into place