volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Accessory Electronic Module Tailored Reversing Warning System|Page 1200 > < Accessory Electronic Module Tailored Reversing Warning System|Page 1198
Page 2
background image

-

Turn the catch (1) a quarter of a turn

-

Fold the side panels on the left and right-hand sides of the cargo compartment inwards. Remove the side panels

-

Pull the tailgate sill trim panel (2) forwards on the right and left hand sides until the two clips on each side release. Carefully pull the panel with
some force as it is tightly secured

-

Remove the wiring (3) for the cargo compartment lighting

-

Pull the sill trim panel straight up until the four clips on the underside release. Remove the sill trim panel.

Remove: 

-

the two nuts from the front edge of the battery holder and the screw from the rear edge

-

the battery holder

-

the cover

-

the battery negative lead

-

the battery, or move the battery to facilitate access.

-

Slacken off the screw (1) almost completely in the rear edge of the wheel arch on the left and right hand sides

-

Press the screw using a screwdriver. This is so that the loose ends on the inside of the bumper cover bend backwards

-

Carefully drill out the rivets (2) underneath the bumper on both sides. Use a Dia. 6 mm (1/4 inch.) drill bit. Do not damage any of the plastic
parts.

Remove: 

Accessory Electronic Module Tailored Reversing Warning System|Page 1200 > < Accessory Electronic Module Tailored Reversing Warning System|Page 1198