S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
-
Remove the yellow protective film from one side of the tape
-
Secure the tape on the sensor holder
-
Carry out the above procedure on the remaining three sensor holders.
-
Remove the protective film from the orange pieces of tape on the sensor holders
-
Install the holders for the sensors. The narrow side must be pointing upward. Install horizontally in line with the bumper casing, as shown in the
figure.
NOTE: The tape secures immediately.
CAUTION: Incorrect positioning of the sensors may result in partial or complete malfunction.
-
Connect the cable harness connectors to the sensors.
NOTE: A click should be heard when connecting. The noise confirms that the catch has locked.
-
Install the sensors in the holders.
-
Clean the inside (1) of the bumper cover where the cable harness is to be secured. Use primer (P/N 8637076) on the cleaned surfaces.
-
Cut out a recess (1) in the right hand inside of the foam to make room for the cable harness for the sensors
-
Reinstall the foam in the bumper cover.