S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
Remove:
-
the wheel
-
the anti-roll bar link from the spring strut.
Note: Use a Torx wrench as a counterhold so that the boot is not damaged.
Remove:
-
the ABS line from the spring strut
-
the ABS sensor. Hang up the sensor using a piece of wire.
Measure the spring strut position in relation to the wheel spindle before removal
Note: The measurements are made so that the same camber angle can be obtained when installing.
-
Measure across the wheel spindle/spring strut at the upper screw as illustrated
-
Before measuring clean off any dirt from the measuring surfaces
-
Note the measurement.
Removing the spring strut