S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
-
the spring strut to the wheel spindle. Usenew screws and new nuts.
Adjust the spring strut and wheel spindle to the measured value. See Wheel knuckle / spring strut, calibrating See: Front Steering Knuckle/Service and
Repair/Procedures.
Note! When replacing the shock absorber, the wheel camber alignment must be adjusted. See Wheel alignment, checking / adjusting See:
Alignment/Service and Repair.
Tighten to 105 Nm. Angle-tighten 90°. Use bevel protractor 951 2050 BEVEL PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protractor
-
the anti-roll bar link to the spring strut. Use a new nut. Tighten to 50 Nm. Counterhold with a Torx wrench to prevent damage to the boot
-
the ABS sensor.
Note! Ensure that the ABS sensor seat in the wheel spindle is completely clean. Clean the ABS sensor with a soft brush. Tighten the
sensor. Tighten to 10 Nm.
-
the ABS sensor cable
-
the wheel. See Installing wheels See: Wheels and Tires/Wheels/Service and Repair.
Shock Absorber Bearing Upper Rear, Replacing
Shock absorber bearing, upper rear, replacing
Removing the rear shock absorber upper bearing
Remove
-
the shock absorber and spring. See Spring rear, replacing, M66, TF-80SC, AW55-50/51SN, M56 See: Suspension Spring ( Coil / Leaf )/Service
and Repair/Rear Suspension/Spring Rear, Replacing
-
the three screws holding the upper bearing for the shock absorber
-
the upper bearing.
Installing the rear shock absorber upper bearing
Install
-
the shock absorber upper bearing in reverse order. Tighten to 25 Nm
-
the shock absorber and spring. See Spring rear, replacing, M66, TF-80SC, AW55-50/51SN, M56 See: Suspension Spring ( Coil / Leaf )/Service