S60 T5 L5-2.3L Turbo VIN 53 B5234T3 (2002)
(The illustration displays the rear wheel hub schematically)
Note: Ensure that the hub and the wheel spindle mating surfaces are clean.
Install
-
the rear wheel hub. Use new screws and torque wrench with ring wrench kit. Tighten crosswise.
Tighten to 20 Nm.
Then tighten to 65 Nm.
Finally angle-tighten 60°. Use bevel protractor 951 2050.
Note: The screw without a flange has a washer which is included in the kit. Position the screw in the rear lower screw hole.
-
the brake disc
-
the locating pin for the brake disc. Tighten the locating pin. Tighten to 10 Nm
-
the brake caliper. Use new screws. Tighten to 60 Nm
-
the ABS sensor.
Note: Ensure that the sensor seat in the wheel spindle is completely clean.
Clean the ABS sensor with a soft brush. Tighten the sensor. Tighten to 10 Nm.
-
the ABS-cable holder
-
the wheel.