S70 L5-2.4L VIN 55 B5254S (1998)
-
Check that the cable is straight where it enters the drive gear housing.
-
When installing the impact protection: check that the impact protection is not contacting the SIPS airbag's gas generator.
SIPS airbag, removing the safety device
Remove the transport safety device from the sensor module and return it to its storage place on the inside of the control panel.
Drive Shaft Under Seat, Replacement
Drive shaft under seat, replacement
Preparations
CAUTION! Install the transport safety device for the SIPS Airbag.
Removing
Make a note of radio code if anti-theft coded radio is installed.
Remove:
-
Battery negative lead.
-
Seat from car.
-
The control module from the bracket. Control module, See: Power Seat Control Module/Service and Repair
-
The control module bracket.
-
Mark up motors.
-
Motors 1, 3 and 4. Motors and potentiometers underneath seat, See: Power Seat Motor/Service and Repair
-
The screws from the height adjuster. See illustration.
-
Remove the screws from the seat frame. See illustration.
-
Remove the seat rails from the seat frame.
-
Remove the drive shaft between drive gear and seat rail.