S70 L5-2.4L VIN 55 B5254S (1998)
DISASSEMBLING AND REASSEMBLING OF CONNECTOR
3. Disassembling
-
Separate the connector on transmission.
-
Disassemble connector. Remember rubber gasket.
-
Disconnect cable clamps and detach connector from transmission.
-
Remove sockets from connector casing.
-
Remove rubber seal from connector.
-
Insert screwdriver between casing and socket and press catch in.
At the same time slide the sockets out of the casing.
4. Detach socket for gear position sensor (8-pin) from other sockets.
-
Remove gear position sensor.
5. Reassembling
-
Reassemble position sensor socket with the other sockets.
-
Reinstall sockets in casing and put rubber seal back in place.
-
Reinstall connector on transmission.
-
Reinstall cable clamps around cable harness and rubber seal.