S70 L5-2.4L VIN 55 B5254S (1998)
-
Install new TCM.
-
Ignition ON.
-
Read off any DTCs set and then clear them.
4. Adaptation of the throttle position TP signal
-
The TP signal must be adapted whenever a new control module is installed.
-
Proceed as follows:
Block all four wheels
Start engine.
NOTE: Apply parking brake and press down hard on the brake pedal with left foot during the entire procedure.
Set gearshift selector to position D
Fully depress the Accelerator Pedal (AP) so the kickdown switch closes.
Keep the AP fully depressed for 5 seconds
Release the AP and set the gearshift selector to position P.
The TP signal is now adapted to the new TCM.