Front Seat Belt Buckle and Seat Belt Tensioner Replacement
-
Check that the seat belt (inertia) reel locks as it should. Test this by pulling it out and jerking it repeatedly.
Unsecure The SIPS-bag
NOTE: If the seat is not equipped with a SIPS-bag, continue with installing front seat seat compartment.
WARNING: If the front seat is equipped with a SIPS bag this must be unsecured when work is finished. Remove the transport safety device from the
SIPS sensor. Never apply external force to side of seat.
-
Remove the transport safety device from the SIPS sensor.
-
Install the transport safety device in the holder on the inside of the cover.
Installing Front Seat Seat Compartment
-
Install seat compartment.
The figure shows a mechanical front seat.
For power seat:
Connect connector to power seat control module. The control module is located under the seat.
Final Check
WARNING: Ensure that nobody is in the car when the battery is being connected.
When all components have been reinstalled:
-
Switch the ignition to position II.