S70 L5-2.4L VIN 55 B5254S (1998)
Body/Service and Repair
(Solenoid STH is calibrated together with the control system).
21. Replacing solenoid
-
Remove solenoid retaining screws
-
The illustration shows solenoids SL, S1 and cable harness, early version.
-
Remove solenoids from control system.
-
Install new solenoids.
-
Lubricate solenoid O-rings (S1, S2, SL) with a little Vaseline.
Install solenoids and tighten screws to: 10 Nm
22. Reinstallation of control system
-
Reinstall gear selector slide in control system as illustrated.
-
Install new seals in transmission.
Use Vaseline to hold seals in position.
23. Install control system in transmission.
-
Insert arm on gear selector slide in hole in gear selector cam.
-
Install screws.
Note that screws are of different lengths (measured in mm. see illustration).
NOTE:
-
Tighten screws alternately.
-
Tighten to: 10 Nm
-
Install cover with new gasket.
Tighten to: 10 Nm