S70 L5-2.4L VIN 55 B5254S (1998)
5. Remove balls
-
Tilt inner race and cage and remove balls clockwise, one by one.
Use an electric scriber to mark where you started removing the balls.
-
Put the balls in order so they can be put back in the same position later.
6. Remove cage and inner ring from shaft.
-
Rotate inner race 90° relative to cage.
-
Remove inner race.
-
Remove circlip from inner race.
7. Clean all CV joint components thoroughly.
If any part shows signs of cracking or scoring, replace entire CV assembly
NOTE: Slight scoring or pitting in races is acceptable.
8. Installing inner race in cage.
-
Line up markings and put the first ball in.
NOTE: Carefully note positions of balls.