S70 L5-2.4L VIN 61 B5244S (2000)
(The illustration shows a bottom view). Remove the screw (1) and (2). Discard the screws.
Installing the bracket, continued
5
Install the bracket (1) with the gas spring into place. (see illustration).
Install a new screw (2) and a new washer (3). Finger tight.
Note!
The thicker washer (3) shall be located (screw 2) between the bracket and gearbox/motor.
Note!
Check that the bracket (1) and the bracket/ clamp assembly on the SIPS tube are lined up in a straight line.
NOTE:
Ensure that the circlip is installed correctly in pivot grooves.
Installing the bracket
6