S70 L5-2.4L VIN 61 B5244S (2000)
^
Put a block of wood in front of piston. Push piston out carefully using compressed air.
^
Remove dirt guard (3).
^
Remove O-ring (4). Use weatherstrip tool 981 4071 or similar so as not to damage edges of groove.
^
Remove rubber bushings (7) and bleed nipple (5).
Cleaning and inspection
^
Clean components in T-spirit. Check for wear, damage, cracks and rust. Replace components if necessary.
^
Always replace O-ring and dirt guard during overhaul. Take particular care to clean ducts and grooves for O- ring and dirt guard.
^
If cylinder is badly marked, scratched etc., replace complete caliper.
^
Remove minor rust deposits with fine sandpaper.
Assembling brake caliper
^
Blow ducts clean with compressed air.
^
Coat cylinder lining, piston (2) and new O-ring (4) with brake fluid.
^
Install lubricated O-ring (4) in groove in cylinder. Install dirt guard in end of piston (see illustration).
^
Install dirt guard in groove inside cylinder and push piston in carefully.
^
Check that dirt guard slots into its groove in the piston.