S70 L5-2.4L VIN 61 B5244S (2000)
^
Filler cap.
Set bleeding unit to 0.2 - 0.3 MPa (29 - 42.7 psi).
Connecting bleeding unit
^
Connect bleeding unit to brake fluid reservoir.
Follow manufacturers' instructions for connecting and using bleeding unit.
^
Depress brake pedal a few times to expel any air bubbles from the master cylinder.
Note: Repeat this step between bleeding each brake caliper.
Bleeding LH front wheel
Remove:
^
Protective cap from bleed nipple and connect hose from drain bottle.
Open bleed nipple and close it again once no further air bubbles can be seen in the escaping fluid.
Tighten bleed nipple.