S70 L5-2.4L VIN 61 B5244S (2000)
Brake Fluid Pressure Sensor/Switch: Service and Repair
EBD-pressure sensor, replacement
Preparations
Clean around EBD pressure sensor connection to master cylinder.
Put rags under the EBD pressure sensor to protect painted surfaces against brake fluid spillage.
Get a drain bottle and hose to collect brake fluid in.
Removing EBD pressure sensor
Ignition off.
Jack front end of car up.
^
Disconnect connector from EBD pressure sensor.
Remove:
^
Protective cap from bleed nipple by LH front wheel.
^
Connect hose to drain bottle.
^
Open bleed nipple, depress brake pedal and hold it down or lock it in that position.
^
Close bleed nipple.
^
Remove EBD pressure sensor and plug connector so that no dirt enters the braking system.
Check EBD pressure sensor