S70 L5-2.4L VIN 61 B5244S (2000)
-
The power brake booster with the connector for the relief valve (1) at four o'clock.
-
Connect the push rod to the brake pedal.
-
The retaining clip
-
The four new mounting nuts. Tighten to 25 Nm
-
The main cylinder. See (Not for VADIS use) Master cylinder, replacement
-
The bracket with the ABS hydraulic modulator. See Replacing the hydraulic unit. Then continue according to instructions below.
Finishing work
It is important that the stop lamp switch is set after the brake pedal lever has been disconnected from the power brake booster.
-
Remove and install the stop lamp switch. Adjust as required
-
Install the sound insulation under the steering wheel.