S70 L5-2.4L VIN 61 B5244S (2000)
Carefully press in tool 999 5651 between the sealing ring and the camshaft.
Carefully pry out the seal.
Cleaning
To clean the shaft journal and mating surface, use emery cloth PIN 9511024.
Note! When cleaning work around the shaft journal, not in and out. It is essential that any residue from the emery cloth and any other contaminants are
completely removed before the new sealing ring is installed.
Oil the new seal.
Install the new seal for the exhaust camshaft. Use drift 999 5719.
Install the new seal for the intake camshaft. Use drift 999 5718.
Remove the engine cooling fan (FC)
Remove:
-
slacken off the brake vacuum hose from the intake
-
the air cleaner (ACL) housing intake pipe from the connection above the radiator. Twist the pipe up
-
the manifold absolute pressure (MAP) sensor from the front cover plate
-
the canister purge (CP) valve from the engine cooling fan (FC) shroud
-
release the wiring from the fan shroud.
Lift out the hose for the expansion tank from the holders on top of the fan shroud.
Disconnect both the engine cooling fan (FC) connectors.
-
both screws holding the fan shroud.
Carefully lift up the engine cooling fan (FC).
Install radiator protection 999 5474.
Secure the crankshaft position
Install the adjustment tool.