S70 L5-2.4L VIN 61 B5244S (2000)
the front timing belt cover. Tighten to 12 Nm
the cover over the ignition coils
the upper timing belt cover.
the auxiliaries belt.
the expansion tank.
the servo reservoir. Check that the hoses are correctly positioned.
the starter motor. Tighten the screws at the transmission to 40 Nm
Tighten the support bracket screw to 25 Nm
Remove the radiator protector
Carefully lower the fan shroud. Align it with the holders at the sides of the radiator.
Tighten both the mounting screws.
Connect the engine cooling fan (FC) connectors.
Press the hose down from the expansion tank into the holder on the fan shroud.
Secure the wiring with tie straps as before.
Press the manifold absolute pressure (MAP) sensor onto the holder at the front cover plate.
Press the evaporative emission system (EVAP) valve into the holder on the fan shroud.
Turn down the air cleaner (ACL) intake manifold and locate against the sleeve connector above the air conditioning aggregate.
Install
-
the brake vacuum hose
-
the trigger wheel. Tighten to 17 Nm
-
the camshaft position (CMP) sensor housing and a new cover. Tighten to 17 Nm
-
the torque rod bracket. Tighten to 50 Nm
-
the inlet hose between the air cleaner (ACL) and throttle body (TB)
-
the crankcase ventilation hose on the inlet hose
-
the plastic nuts for the cover in fender liner
-
the wheel.
-
the engine stabilizer brace. Tighten the screws at the suspension turrets. Tighten to 50 Nm. Tighten the engine bracket screw. Tighten to 80 Nm
-
the cable to the battery negative terminal.
Checking the engine
Test drive the car to check the function of the engine.
Rear camshaft seal
