S70 L5-2.4L VIN 61 B5244S (2000)
Lubricate screws.
Tighten screws in three stages from the middle and working out according to:
1. 20 Nm
2. 60 Nm
3. 130°, use bevel protractor 951 2050
Install coolant pipe with a new gasket.
Install new O-rings around the spark plug wells.
Remove spark plugs 1 and 5.
Apply liquid gasket
Apply liquid gasket P/N 1 161 059-9 to the upper half of the cylinder head using a short-bristle roller.
Caution: Ensure that no liquid gasket enters the oil channels. A thin layer is enough to form a seal.
Install camshafts. Secure front of camshafts using holder 999 5453 and rear of camshafts using camshaft adjustment tool 999 5452 ((without
extensions).
Install upper half of cylinder head
Position upper half.
Pull down onto cylinder head using press tool 999 5454 (two).
Torque the upper section from the inside outwards, tighten to 17 Nm.
Remove camshaft adjustment tool (999 5453) and tool (999 5454)
Install front camshaft seals