S70 L5-2.4L VIN 61 B5244S (2000)
Tightening Engine Mounts (Part 2 Of 2)
-
torque rod, tighten to 35 Nm (26 ft. lbs. and angle- tighten 90°
-
torque control arm stay, tighten screws to 10 Nm (7.3 ft. lbs. and nut to 25 Nm (18 ft. lbs.
-
trigger and Camshaft Position Sensor (CMP)
-
rotor and distributor cap
-
connect ignition cables
-
Air Cleaner (ACL) housing assembly including intake pipe and hoses
-
Turbocharger (TC) control valve (if applicable).
Install
-
timing covers
-
fuel rail. Lubricate injector O-rings with Vaseline. Remove holder 999 5533 and 999 5620 (from and including model year 199S).
-
cover over ignition cables
-
charge air pipe over engine (turbo charged engines only).
NOTE! Remove temporary seal.
-
cover over throttle pulley
-
the two ground strips
-
battery negative lead to battery.
Reset clock and anti-theft radio code.