S70 L5-2.4L VIN 61 B5244S (2000)
Engine Control Module: Service and Repair
Reading the Control Module ID. ETM
Reading the control module ID
-
Ignition on or start engine.
Read control module ID by clicking on the VCT 2000 symbol.
Identifying control module
The information that is Read identifies the control module hardware and software versions and the diagnostic status.
Communication fault
Communication has been interrupted for one of the following reasons:
-
Ignition switched off.
-
The switch is not in position for VCT 2000.
-
VCT 2000 disconnected from Data Link Connector (DLC).
-
VCT 2000 disconnected from VADIS cart/switch.
-
Communication problems in VADIS application or in car.
Check therefore:
-
that the ignition is on and switch is in correct position for VCT 2000.
-
that battery voltage (system voltage) is normal (approximately 12 V). If necessary a battery charger can be connected during the test.
-
that VCT 2000 is correctly connected to VADIS cart/switch and Data Link Connector (DLC).
-
that VCT 2000 and wiring is fault-free.
Try to establish communication again or exit Reading Diagnostic Trouble Codes (DTCs). Depending on the communication fault, select one of the
following alternatives.
-
Try again.
-
Fault-trace more comprehensively for the communication problem that has occurred.
-
Exit fault-tracing / Read from next system.
Selecting the model
Select the car model to obtain the relevant fault tracing data.