S70 L5-2.4L VIN 61 B5244S (2000)
-
Check that the groove on the ball joint spindle lines up with the screw hole in the wheel spindle.
NOTE: Press the ball joint upwards so that the conical top is visible above the screwed joint on the wheel spindle.
-
Use a new locknut in the wheel spindle screw.
-
Tighten to 50 Nm.
Finishing
-
Install the wheel.
Replacing Control Arm (Steel) and/or Control Arm Bushings
Special Tools
999 5481
999 5482
999 5483
Note! The steel control arm with integral ball joint was introduced on cars manufactured from and including January 1994. The ball joint cannot be
replaced separately.
Removing control arm
Remove: