volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Fluid - A/T|Capacity Specifications|Page 5347 > < Fluid - A/T|Capacity Specifications|Page 5345
Page 1
background image

Fluid - A/T: Service and Repair

Oil, changing

Note:

Use only ATF oil, Volvo P/N 1161540-8 (1 liter container), 1161640-6 (4 liter container) may be used

Warning!

Avoid skin contact with transmission fluid. the oil may be very hot if the car has just been driven

Conditions 

The oil should be replaced only in the two following instances:
-

Where diagnostic trouble code (DTC) TCM 0042 and TCM 0046 are stored, in which case the diagnostic function activates the warning lamp in
the following circumstances.
The transmission control module (TCM) receives data about the operating temperature of the transmission fluid while the car is being driven.
TCM 0042 is stored after an accumulated amount of time.
Diagnostic trouble code (DTC) TCM 0046 is stored if the transmission fluid temperature exceeds 150°C for more then two minutes.

-

In cars used in continuous taxi service or used for towing a trailer or caravan for most of its mileage, the oil must be replaced at a service interval
of 75000km ±5000km. This is to conform to the regular service program

Warning!

Avoid skin contact with transmission fluid. the oil may be very hot if the car has just been driven

Draining

Remove

-

the splash guard under engine (certain versions)

-

oil plug. Drain oil from the transmission.

Installing oil plug

-

Use a new gasket

-

Tighten plug. Tighten to 40 Nm

-

Install the protective cover (certain versions)

Preparing to flush the transmission

Fluid - A/T|Capacity Specifications|Page 5347 > < Fluid - A/T|Capacity Specifications|Page 5345