S70 GLT L5-2.4L Turbo VIN 56 B5244T (2000)
Hint: Normally the seal is positioned flush with the internal bevel. If there are grooves on the shaft journal the seal can be pressed in a further 2 mm,
by reversing the sleeve.
Install
-
torque control arm, with brackets
-
rotor with holder
-
Camshaft Position (CMP) sensor with trigger wheel
-
spark plugs
-
distributor cap and ignition cables
-
Air Cleaner (ACL) housing with all hoses and connectors
Install
-
exhaust manifold according to operation Check/replacing exhaust system, refer to Exhaust System.
-
intake manifold and engine Cooling Fan (FC) according to operation Replacing intake manifold, refer to Intake Manifold, Service and Repair.
-
fuel rail
-
ground strip on engine
-
exhaust pipe
-
splashguard under engine
Top up coolant/Change oil and oil filter
Install battery negative lead