S70 GLT L5-2.4L Turbo VIN 56 B5254T (1998)
Thermostat: Testing and Inspection
NOTE:
-
Drain off about two liters of coolant. Remove expansion tank cap.
-
Open nipple on left underside of radiator, use hose to collect coolant. Close nipple.
Thermostat Replacement
1. Removal/installation thermostat:
-
Remove thermostat housing cover hose and remove thermostat and gasket (Torx 40).
-
Clean thermostat housing gasket surfaces.
-
Install new thermostat seal.
-
Install thermostat in housing, install and tighten cover and hose.
-
Fill with coolant and run engine warm until the thermostat opens. Top up if necessary.
-
Check for leaks.
Thermostat Check
2. Check opening function:
-
Thermostat can be tested in hot water.
-
Maximum opening should occur within two minutes in water at opening temperature.
-
Marking: 87
Starts to open at: 87°C (189°F)
Fully open at: 102°C (216°F)
-
Marking: 90
Starts to open at: 90°C (194°F)
Fully open at: 105°C (221°F)