S70 GLT L5-2.4L Turbo VIN 56 B5254T (1998)
-
Route the wiring from the contact reel through the steering wheel
-
Carefully install the steering wheel so that both catches on the contact reel are seated in the two recesses in the steering wheel hub
-
Note! Check that the markings / scoring correspond between the steering shaft and the steering wheel hub.
-
Install the steering wheel screw
-
Finger tighten.
Note! Do not turn the steering wheel when it is on the steering shaft. The contact reel is locked and may be damaged if the steering wheel is turned.
-
Remove the screw locking the contact reel. Install the looking screw in the hole in the steering wheel
-
Tighten the screw in the center of the steering wheel. Tighten to 40 Nm.
Installing the steering wheel module
-
Turn the ignition key to position I to unlock the steering wheel
-
Position the lower section of the steering wheel module against the steering wheel (1)
-
Connect the connector (2)
-
Fold in the steering wheel module using Torx screws from the rear
-
First install the right-hand screw. Turn the steering wheel to gain access to the screws
-
Tighten to 10 Nm.
Check
Check that the steering wheel can be turned easily.
After securing all the components switch on the ignition to position II.
Connect the battery negative lead.
Note! Ensure that nobody is inside the car when the battery is being connected.
Check that the SRS warning light goes out.