S80 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Take the power supply cable for the CD-changer from the kit. Connect the ground lead to the front ground terminal (1) in the rear seat
-
Route the power supply cable and the DIN cable on the right-hand side of the air duct (2) and under the wiring. Continue out through the hole in
the car body behind the left-hand backrest and along the left-hand side of the cable duct (3). Position the single pre-routed red/white (R/W) cables
by the rear fuse holder.
Illustration B applies to cars from model year 2005- (CH 390000-)
-
Route the DIN cable (1) along the two cable ducts (2) under the insulation panel and out through the hole in the bodywork to the engine
compartment
-
Route the DIN cable under the four connectors in the front cable duct.
Applies to cars from model year 2005- (CH 390000-)
-
Take the cable (1) for power supply from the kit. Connect the ground lead to the existing ground terminal behind the battery. Tighten the screw.
Tighten to 10 Nm (7 lbf.ft.). Position the red/white (R/W) single cables (2) by the rear fuse holder
-
Route the cable harness on the left-hand side of the cable duct. The cable with the blue connector (3) must be routed to the pre-routed connector
for the DIN cable.
