volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

CD-Box (in the Glove Compartment)|Page 21757 > < CD-Box (in the Glove Compartment)|Page 21755
Page 7
background image

Applies to cars from model year 2005- (CH 390000-) 

-

Take the cable (1) for power supply from the kit. Connect the ground lead to the existing ground terminal behind the battery. Tighten the screw.
Tighten to 10 Nm (7 lbf.ft.). Position the red/white (R/W) single cables (2) by the rear fuse holder

-

Route the cable harness on the left-hand side of the cable duct. The cable with the blue connector (3) must be routed to the pre-routed connector
for the DIN cable.

Applies to all models

-

Install the small bracket (1) (for the CD ROM reader bracket) in the rear crossmember under the left tail lamp. Use the screw (2) from the kit.

Connection in the fuse holder

Applies to cars up to and including model year -2004 (CH -389999) 

-

Remove the rear electronic module (REM). First open the catch (1) on the top of the module. Fold the module forward. Lift the module from the
mountings (2).

CD-Box (in the Glove Compartment)|Page 21757 > < CD-Box (in the Glove Compartment)|Page 21755