S80 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Install the expander nut in the hole, with the locating pin in the guide hole
-
Route the cable, including the ground lead, from the front socket from above and downwards. Let the cables hang down to the ground.
-
Connect the cable to the front engine block heater socket
-
Press downwards and turn the cable clockwise so that the expander nut engages
-
Align the cable from the front socket so that the hinge is pointing towards the headlamp
-
Remove the connection cable.
Points 5 -9 apply to the XC70
-
Clean the bumper cover where the two pieces of tape will be secured
-
Apply two pieces of tape to mark the holes for the engine block heater switch (use thin tape). Apply one piece of tape at the rear edge, under the
corner of the indicator lamp, vertically down. Position the underside of the second piece of tape along the upper radius of the bumper cover as
illustrated.
