S80 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Remove the brake pipe from the clamps in the side impact protection member
-
Remove the clamp holding the cable to the left rear heated oxygen sensor (HO2S) from the side impact protection member
-
Remove the side impact protection member
-
Pull the exhaust pipes off the manifolds. Allow them to rest on the rear side impact protection member.
-
Clean and spray rust solvent spray on the free ends of the studs for the left-hand manifold
-
Remove the nuts (1) for the left-hand manifold mounting on the engine
-
Pull the manifold off the exhaust pipe. Lift the manifold up from the engine. Place the manifold to one side.
Applies to the S80 with six cylinders, naturally aspirated engine and automatic gearbox
Illustration A
-
Clean the area where the heater will be positioned. This ensures optimal heat conduction to the cylinder block. Also clean the internal thread
-
Install the heater on the cylinder block from the top.
Hint: First secure the tensioner (2) to the engine block heater. Use a small piece of butyl tape. Then secure the inner spacer washer (1), t =10 mm /
25/64", to the reverse of the tensioner. Use butyl tape.
