S80 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Electric engine block heater
Points 1-4 apply to the S80
-
Secure the adhesive template. Use the template to mark up the bumper for holes
-
Drill a hole. Use a 4 mm (5/32") diameter drill bit
-
Drill a hole at right-angles to the surface. Use a 29 mm (1 1/8") diameter hole saw
-
Adjust the guide hole using a round file
-
Also adjust the lead-in hole if necessary.
-
Open the drain holes on both sides. Use a screwdriver. Press in by hand at the markings.
