S80 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
In reverse order
Vacuum pump and test the system. See Refrigerant, draining See: Service and Repair/Refrigerant, Draining
Fill the system with refrigerant. Check for leaks. See Refrigerant, draining See: Service and Repair/Refrigerant, Draining.
Install the battery lead. See Battery, replacing See: Starting and Charging/Battery/Service and Repair/Removal and Replacement/Battery, Replacing.
Ordering software
Order the software. See: Testing and Inspection/Programming and Relearning/Software Downloading.
Finishing
After replacing the control module, the following must be carried out.
-
Reprogram the customer programmed data.
-
Carry out self-adjustment of the damper motor end positions.
-
Test drive the car. Check that the function of the engine is OK.
-
Then check that no diagnostic trouble codes have been stored during the replacement.
Information about programming the control module, damper motor self-adjustment and reading off diagnostic trouble codes can be found under VIDA
vehicle communication.