S80 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Auxiliary Cabin Heater Control Module: Service and Repair
Control module engine coolant heater, replacing
As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential
information in the illustrations is always correct.
Preparations
Remove the battery lead. See Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting.
Remove:
-
the bumper cover. See Casing, bumper front, replacing See: Body and Frame/Bumper/Front Bumper/Front Bumper Cover / Fascia/Service and
Repair/Casing, Bumper Front, Replacing (S80), Casing, bumper front, replacing See: Body and Frame/Bumper/Front Bumper/Front Bumper
Cover / Fascia/Service and Repair/Casing Bumper Front, Replacing (V70), (V70XC) or(S60)
-
the two upper screws (as illustrated) and the center screw on the left hand slide mounting
-
the left air baffle.
Removing the control module for the engine coolant heater
Points to observe when replacing the control module:
-
If moving a control module from one car to another, remember to note any diagnostic trouble code (DTC)(s) and operating times before removing
the control module from the car
-
Always check that the terminals or pins in the control module connectors are not bent or damaged. This may have been the cause of the fault.