S80 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Tape the insulation mat (1) as illustrated.
Image A applies to the installation of ISOFIX on the side where the seat belt's single buckle is located.
Image B applies to the installation of ISOFIX on the side of the car where the seat belt's double buckle is located.
Note! The S80 has the opposite seat belt geometry to the V70 (00-), i.e. the seat belt's double buckle is located on the opposite side.
Carry out on both sides
-
Remove the screw (1). For the single buckle - remove the middle seat belt's end mounting (2).
-
Replace the screw (1) with a new screw from the kit.
-
Expose the existing stud (5) by removing the perforated part of the insulation under the ISOFIX bracket (3).
-
Position the ISOFIX bracket (3) as illustrated.
-
Install the screw (1). For the single buckle - together with the middle seat belt's end mounting (2).
-
Install nut (4) and washer (6), from the kit.
-
Tighten the screw (1) to 40 Nm (30 lbf.ft.) and then tighten nut (4) to 30 Nm (22 lbf.ft.).
Applies to the V70 (00-)
-
Fold the rear seat cushion back into place.
