S80 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Remove the 2x M8 screws.
Disconnect the 2x connectors.
Remove the control module and the bracket.
Installation
Note! For tightening torques, see Specifications See: Specifications/Mechanical Specifications/Starting and Charging.
Installing the suspension module (SUM)
Connect the 2x connectors.
Install the 2x screws. (M8). Tighten.
Finishing work
Fold the carpet back into position.
Install the panel for the center console.
The Suspension Module (SUM) must be programmed after replacement.
Ordering software
Order software according to the table below.
Finishing
Note! After replacing the Suspension Module (SUM), the position sensors and the resistance of the shock absorbers must be calibrated.
Read off and erase any diagnostic trouble codes (DTCs) stored during the replacement.
Test the function.