S80 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Install the adjustment nut.
Use wrench 999 5371 NUTS-DIFF.BEARING) 1035 See: Tools and Equipment/999 5371 Nuts-Diff. .Bearing 1035 Turn the propeller shaft when the
nut is tightened to its previously measured position.
Checking the marking
Check that the marking corresponds exactly. Check the height. See Marking the position of the adjustment nut.
Install the split pin. Tighten the screw. Tighten to 50 Nm.
Checking the oil level in the bevel gear
Check the oil level in the bevel gear. See Bevel gear, B5254T2, AW50/51 AWD See: Service and Repair/Removal and Replacement/Automatic
Transmission Components/Bevel Gear, Replacing.
Note! To install the drive shaft, see Bevel gear, B5254T2, AW50/51 AWD See: Service and Repair/Removal and Replacement/Automatic
Transmission Components/Bevel Gear, Replacing.
