S80 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Install the gear selector cable under the heater unit on the left-hand side, down towards the hole.
Note! Be extremely careful when running the rubber bellow for the gear selector cable through the hole in the firewall. The gear selector cable
must not be damaged.
Feed the gear selector cable through the hole slightly.
Hint: Route the gear selector cable correctly in the engine compartment with someone to assist you.
Locate the grommet on the studs
Install:
-
the nuts. Tighten to 12 Nm
-
the air ducts
-
the stay and the screws. Tighten to 10 Nm.
Feed the gear selector cable in from the inside
