S80 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Seals and Gaskets: Service and Repair
Seal, Drive Shaft, Replacing
Seal, drive shaft, replacing
Special tools:
999 1801 STANDARD SHAFT See: Tools and Equipment/999 1801 Standard Shaft
999 5541 PUNCH See: Tools and Equipment/999 5541 Punch
Left-hand side
Preparatory removal
See.
Remove the drive shaft seal
Use a jimmy bar with a flat surface. Turn the flat surface towards the transmission housing.
Install the drive shaft seal
Note! Clean thoroughly before installing the new seal
Apply a small amount of grease to the sealing lip.
Use drift 999 5541 PUNCH See: Tools and Equipment/999 5541 Punch and shaft 999 1801 STANDARD SHAFT See: Tools and Equipment/999 1801
Standard Shaft.
Place the side of the drift marked M56 against the drive shaft seal.
Install the drive shaft in the transmission
See Drive shaft left, replacing, B5254T2, M56 See: Axle Shaft Assembly/Service and Repair
Right-hand side
Preparations
